So I have been doing some research for a tougher clutch and was wondering if anyone has had experience with any of the following in a 2.9,
Centerforce Dual Friction
Zoom Hi Performance Kevlar
Luk Gold Series
clutches
Re: clutches
hey I just got a luk gold put in at the shop .....havnt driven much but its alot better then the motomaster shit i had before
-
- Posts: 38
- Joined: Sun Jun 03, 2007 2:45 pm
- Location: Omaha, NE
Re: clutches
is the Luk gold a multi-Friction clutch?
- Ranger Dave
- Posts: 1435
- Joined: Sun Oct 10, 2004 5:53 am
- Location: Newbury NH
- Contact:
Re: clutches
regear it,that will make it easier on the cultch 

Last edited by Ranger Dave on Fri Jan 30, 2009 11:38 am, edited 1 time in total.
-
- Posts: 38
- Joined: Sun Jun 03, 2007 2:45 pm
- Location: Omaha, NE
Re: clutches
I plan on regearing it, but my rear main is leaking so Im just trying to see what options I have for clutches since Ill probably just replace it since I got the tranny out.
Re: clutches
I can't remeber all the details but I would look into going with a 4.0L flywheel/clutch. I think I remeber seeing info on it at the rangerstation.com a long time ago when I was doing my motor swap...
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...
http://www.catalystcycles.com
http://www.catalystcycles.com