radius arm brackets

cddavis9343 · Post by **cddavis9343** » Fri Apr 20, 2007 2:04 pm

when i lift my bii the front drive shaft hits the cross member under it. its the cross member the radius arms are connected with. how do i stop this, and can i cut it out?

bartmantom · Post by **bartmantom** » Fri Apr 20, 2007 9:47 pm

DON'T CUT IT!!! that would be bad, very bad!!!

(If I remember right, it unbolts). With your lift you should have gotten a set of radius arm drop brackets. these will lower the cross member between them, if I remeber correctly.

Rockcrawler · Post by **Rockcrawler** » Sat Apr 21, 2007 11:52 am

did you get a drop bracket for the radius arms?

cddavis9343 · Post by **cddavis9343** » Sun Apr 22, 2007 12:12 pm

no drop bracket just dropped the towers and put blocks in the back can i fab my own drop brackets out of the old ones?