got bored, went to the junkyard and scored

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
User avatar
onewyr
Posts: 84
Joined: Sat Oct 07, 2006 7:53 pm
Location: chesapeake va
Contact:

got bored, went to the junkyard and scored

Post by onewyr »

I got off of work and my side kick came over and we were bored so we went to the local pick-n-pull, because I had some credit there. Didn't really know what we were looking for but who cares right. Cause a bad day at the junk yard is better than a good day at work right. We started of trying to find some buckets for the rear of my BII, found some possibilities but nothing to hollar about. then we went and looked at the taurus for an electric fan and got one. then we went back and found a throttlebody off of an 86' and there is a pretty good difference in size. it was the only one and I got it. I also found a rear gate with the flip up window but there was too much play in the window. so for not knowing what I was looking for I think I did pretty good. If anyone happens to know what other parts I need to make this fan work please let me know I would like it to work on a temp switch or something like that
DBrown
Posts: 1545
Joined: Mon Apr 19, 2004 5:21 am
Location: Bowling Green, KY

Post by DBrown »

just wire it to kick on when the key is in the on position.
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...

http://www.catalystcycles.com
User avatar
onewyr
Posts: 84
Joined: Sat Oct 07, 2006 7:53 pm
Location: chesapeake va
Contact:

Post by onewyr »

I would rather have it come on with a temp switch cause if the motor doesn't get to the right temp it will not run right
Post Reply