Page 1 of 1

fabrication on frame

Posted: Wed Oct 07, 2015 7:47 am
by vvp
hello this is vvp. I am putting a ranger cab onto a bronco2 question is what is the trick for the rear cab mounts. does anyone have photos of this process and or and helpful advice? thanks for your time. vvp

Re: fabrication on frame

Posted: Fri Oct 09, 2015 7:54 pm
by tekatlarge
I have seen a thread here a long time ago about someone doing what you are asking about. I remember the rear mount was something built up on each frame rail with a cross member going across the right under the back of the cab.

You might want to do a search here on that subject.