fabrication on frame
fabrication on frame
hello this is vvp. I am putting a ranger cab onto a bronco2 frame.my question is what is the trick for the rear cab mounts. does anyone have photos of this process and or and helpful advice? thanks for your time. vvp
- tekatlarge
- Posts: 980
- Joined: Tue Jan 17, 2006 8:54 am
- Location: Kent, Worshington
Re: fabrication on frame
I have seen a thread here a long time ago about someone doing what you are asking about. I remember the rear mount was something built up on each frame rail with a cross member going across the right under the back of the cab.
You might want to do a search here on that subject.
You might want to do a search here on that subject.
The Tek @ Large
Kent,Worshington
I was borne under a rock. So what's your excuse?
Kent,Worshington
I was borne under a rock. So what's your excuse?