Bronco ii '89 2wd automatic with A4LD
Swapped front axle with '92 explorer 4wd - no issues here
4WD harness and shift control module out of a '91 Explorer
Bronco ii harness has different wires and pin locations than '91 explorer 4wd harness
I've trimmed the connector so they will mate together but need a wiring diagram and/or pin out to swap wires with one of the plugs
Any help would be appreciated.
Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
1 post • Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 1 guest