vacuum lines

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
broncofan
Posts: 75
Joined: Tue Aug 18, 2009 1:12 pm
Location: FT. Hood, TX.

vacuum lines

Post by broncofan »

i have a 84 BII 2.8 motor was runniing really rough. finally had to have the carb rebuilt. think i put all the lines back on right but it idled really high. i'm hoping someone has a readable diagram so i can make sure. any help would be appreciated. i looked in the chiltons manual and they look right.
but it was really smoking bad and idle screw was all the way back. might be time for the v8 swap
2013 Taurus SHO LMS V11 tune, 06 F150 Harley-Davidson Edition,03 Mustang GT Conv, 97 Jeep GC Laredo 5.2, 84 BII
Post Reply