Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
1988 Bronco II issues
Replies: 4
by
garman »
Tue Oct 16, 2012 5:04 pm
Hi Folks,
4 Replies
2533 Views
Last post by drofman
Thu Oct 18, 2012 6:51 pm
7 Replies
6674 Views
Last post by drofman
Thu Oct 18, 2012 6:43 pm
Bronco 2 2x4 to 4x4 conversion
Replies: 9
by
Luke »
Sat Aug 11, 2012 10:41 am
I am wanting to convert my B2 to four wheel drive but everyone I talk to says there is too much to this and don't want to do it. Does anyone know of...
9 Replies
5998 Views
Last post by drofman
Mon Oct 15, 2012 5:30 pm
starter is grinding
Replies: 7
by
laria01 »
Sat Aug 04, 2012 8:28 am
I have an 88 that is awesome. Lately I have been having issues with the starter and flywheel not engaging properly. I had the fly wheel replaced...
7 Replies
5116 Views
Last post by Mudhog1977
Sun Oct 14, 2012 11:00 am
tranny swap
Replies: 3
by
smoky614 »
Fri Oct 12, 2012 6:32 pm
Alright yall, i got myself 88 bronce 2 and im in the process of puttin a new tranny in it, but when i got the tranny from the junk yard i had to...
3 Replies
1533 Views
Last post by shazbot
Sat Oct 13, 2012 9:51 pm
Oh no!
Replies: 7
by
AKBroncoII »
Wed Aug 01, 2012 12:52 pm
Driving to work today, almost to my exit. Everything was running fine, when all of a sudden, Ol' Agnes made a loud bang, ran rough, and then shut...
7 Replies
4415 Views
Last post by Phillippi
Tue Oct 09, 2012 8:05 pm
New guy with an issue
Replies: 2
by
hrdfrntr95 »
Fri Oct 05, 2012 2:28 pm
Hey guys...just got my firat bronco 2. So far i love it. I have a 9094 with the 2.9 and a 5 speed. Interior looks great and only got a few minor rust...
2 Replies
1403 Views
Last post by hrdfrntr95
Tue Oct 09, 2012 4:45 pm
14 Replies
9309 Views
Last post by jgarza
Fri Oct 05, 2012 9:17 pm
bad gas
Replies: 1
by
lmtpop »
Wed Oct 03, 2012 7:30 am
any recommendations for additives to clean out water/ethanol separation? i have siphoned the tank as dry as possible without removing the tank. is...
1 Replies
1215 Views
Last post by kirkland2887
Thu Oct 04, 2012 11:47 am
1 Replies
1320 Views
Last post by jgarza
Sun Sep 30, 2012 11:55 am
front end grind/clunk
Replies: 2
by
4d4life »
Sat Sep 22, 2012 6:52 pm
From the inside its hard to tell but when i take off all the way through first gear i have clunk/grinding noise. I looked at the out put shaft from...
2 Replies
2315 Views
Last post by jefe
Thu Sep 27, 2012 9:35 am
4.6 Mustang GT
by
RAZOR »
Thu Sep 20, 2012 10:50 am
me and one of my friends got a wild idea, since a 4.6L V8 is essentially 2 2.3L L4, will the turbo(s) off of a turbo coupe fit his 4.6, if so how...
0 Replies
2870 Views
Last post by RAZOR
Thu Sep 20, 2012 10:50 am
Gearing
Replies: 18
by
Jbots »
Sat Jul 07, 2012 1:20 am
I was wondering what gear ratio i should get for my b2 thats going on 33s, any iput wouls be appreciated
18 Replies
10823 Views
Last post by JoshKinslow
Sun Sep 16, 2012 8:27 pm
Need some tips for my B2!!!
Replies: 1
by
JoshKinslow »
Sat Sep 15, 2012 8:35 pm
:usa: I need tips on my project. I wanna put an original Bronco front end (grill, headlights, and whatever else I need) If any of you guys have tips...
1 Replies
2008 Views
Last post by JoshKinslow
Sat Sep 15, 2012 9:28 pm
0 Replies
2439 Views
Last post by hatchtravis
Fri Sep 14, 2012 12:30 am
Cant decide what cam/valve springs to use?
Replies: 2
by
Jbots »
Wed Sep 05, 2012 7:27 pm
I have a 1968 302 im putting in my b2 and im trying to get 400 ponies out of it, the only question i have is what camshaft and valve springs do i...
2 Replies
1748 Views
Last post by tekatlarge
Thu Sep 06, 2012 9:17 pm
crazy fuel pressure
Replies: 11
by
kirkland2887 »
Tue Aug 21, 2012 8:21 pm
My 88 2.9 has been randomly dying on me. i know it is a fuel problem. what i dont know is how to tell which pump it is for sure. i hooked up a snap...
11 Replies
4032 Views
Last post by tekatlarge
Thu Sep 06, 2012 8:57 pm
In Tank Pumps '84 vs '90
Replies: 3
by
Dreded »
Sat Aug 25, 2012 12:31 pm
Ok so I FINALLY have the money to finish my second 5.0L BII install and I have a carbed 5.0 in a '90 bII FRAME/body was wondering if anyone knew if...
3 Replies
2264 Views
Last post by CFAIST
Fri Aug 31, 2012 11:52 am
Rear End Question ...
Replies: 3
by
Ronnie_B »
Fri Aug 24, 2012 10:39 am
I have a 1990 Bronco II 4x4. When I bought it, the old gentleman told me he had replaced the rear end but was not sure it was the correct one. Now...
3 Replies
1572 Views
Last post by dirtcowboy
Mon Aug 27, 2012 10:03 pm
should be a real simple question...
Replies: 6
by
BamaBronco2 »
Thu Aug 16, 2012 7:01 pm
I have a 90 B2 4x4 that I just bought. Just under the dash on the driver's side of the truck, there is an unmarked metal handle . It's not the...
6 Replies
3563 Views
Last post by tekatlarge
Wed Aug 22, 2012 12:08 pm
Blown head gasket already....
Replies: 4
by
jefe »
Sun Aug 12, 2012 5:29 pm
So bummed right now.
4 Replies
2120 Views
Last post by drofman
Sun Aug 19, 2012 3:53 pm
1988 bronco ii oxygen sensor location
Replies: 9
by
jgarza »
Mon Aug 13, 2012 11:46 am
Where are they located. My bronco starts up but then starts to low idle at 400,300,200,100 then back to 400. And does that when driving around. I've...
9 Replies
7898 Views
Last post by tekatlarge
Wed Aug 15, 2012 10:03 pm
new and need parts
Replies: 3
by
treel98 »
Sun Aug 12, 2012 7:59 pm
Hey everyone i am new to the sight. I have a 1990 Ford Bronco II. Ok i need mudding advice. any tips and advice. i want to get some performance parts...
3 Replies
1744 Views
Last post by tekatlarge
Wed Aug 15, 2012 12:05 pm
2.9L Valve covers?
Replies: 11
by
CFAIST »
Wed Aug 08, 2012 9:48 am
Hi everyone. Been searching Like a mad man trying to find a replacement Valve cover for my 89 B2. Ford has them obselete (of course) and I cant find...
11 Replies
6408 Views
Last post by jefe
Mon Aug 13, 2012 4:55 pm
Any east tn members?
Replies: 13
by
bigmelton »
Sun Aug 05, 2012 12:02 am
My name is Ryan and I drive a 84 bronco 2 5 speed. Its in really good shape but the hubs dont lock and the pinion is loose. Wanted to see if anybody...
13 Replies
5416 Views
Last post by bigmelton
Sun Aug 12, 2012 8:47 am
Emergency brake
Replies: 4
by
Jbots »
Mon Jun 25, 2012 12:04 pm
So my bronco IIs emergency brake just stopped working and im wondering if anyone else has had this problem and some quick tips for me
4 Replies
4318 Views
Last post by rockland46
Wed Aug 08, 2012 9:07 pm
Spare tire spec
Replies: 1
by
rockland46 »
Wed Aug 08, 2012 8:53 am
Hey!
1 Replies
1116 Views
Last post by jefe
Wed Aug 08, 2012 9:18 am
Transmission help needed!
Replies: 1
by
hamn3r22 »
Mon Jul 16, 2012 5:26 pm
i have an 1984 bronco II with a 302 out of a 82 mustang. it has the stock transmission which im told is c5. the bell housing has been swapped to fit...
1 Replies
1259 Views
Last post by RAZOR
Thu Aug 02, 2012 8:57 pm
6 Replies
3034 Views
Last post by CFAIST
Thu Aug 02, 2012 10:48 am
A4LD Transmission high rpm's before shifting
Replies: 9
by
jefe »
Wed Jul 18, 2012 9:15 am
Hey guys...got an 87 BII 2.9L 4WD with the A4LD transmission.....past couple weeks or so, it's been slow to shift gears, rpm's going up to about 4000...
9 Replies
5827 Views
Last post by kirkland2887
Wed Aug 01, 2012 8:18 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum