BroncoII4x4.com

I ended up putting it behind my glove box or where it used to be. I had to separate the front and back of the GB to fit it behind there. Didn't have to cut wires or buy anything though so it worked out good.
http://www.angelfire.com/80s/broncoiis/BJ1/tech2x.html

Alright thanks, I seen a really cheap one and was wondering about them.

I was wondering if anyone has used a D30 on a B2? What all would be involved with this swap?

what's the charcoal canister? Is that part of the fuel pump? Also, which passenger speaker are you talking about? The six inch in the door or the rear 5x7".

Where does the fuel tank vent at? Is there anything I'm missing. I've vented my axle and T-case. My 5-speed vents at the top, so I think it's high enough for now.

Just wondering what I should do about my computer? Should I bag it or try to relocate it? Has anyone did this?
-BJ-

I've never heard of a BW1356, but I bolted a BW1350 from a 88 Ranger to my 5-speed. The threads were different, but the bolt size the same. I'm not sure if they're any smaller though.

The Amp is not shutting off. The sub will just stop playing. I have been pushing on the sub whenever it shuts off and it will come back on. It seems to be working. For one day it worked fine.

I'm not sure if this is the best place to post this question,but I was wondering if ya'll could help. I will be driving along and my sub will just stop, Everything else still working. An audio shop said the remote wire voltage was dropping close to 10 volts dropping the amp off. They said to hook it ...

James Duff has 3" leaf spring sets for $280 for BII. Just thought I'd mention it.

I've got a game I play too. It's called Cabelas 4x4 offroad. They have 3 games altogether. I like 1, number 2 sucks bad ,and I haven't seen number 3.

I installed the T-case, a BW1350 in my 89' 2wd B2. Everything is fine exept, the shifter when shifted to 2wd loses the lever out of reach and can't bring it back. If I pull the bracket back too far then it can't go into 2wd. I tried for more than a half hour and gave up. If anyone can help it would ...

I got my Hi-lift jack today. Now I need ther winching package and I'll be set.

Have you guys ever had anything snap while winching with the hi-lift?

Hey guys, maybe ya'll should start a room for bad-mouthing bodylifts. My B2 came with a 3in, so no bad-mouthing. I think it looks fine. It does give you more room to work underneath. The frame is visible though. It might look stupid once I put a 6in suspension on it. But for now you have to bend ...

That might come a few years from now. Right now, I'm having fun muddin in my 2wd. Short term I plan on ttb and a 6" lift.In low gear in 2nd it pulled right through a pond 25 foot wide yesterday. In the center there was a rut deep enough my front bumper went under and my muffler was blowin bubbles. I ...