BroncoII4x4.com

Alright, going with a different C4. I have an add in the wanted section. Thanks for the help.

I'm going next week to "rescue it from the shop." Hopefully another shop can figure it out. I am stumped.

It's sitting pretty flat.
It's losing enough pressure that it will go into gear for about a minute. Then when the fluid gets warm it will just slip.

Yup, both C4. I think the code came back that the tranny is from an early 80's F150 and the bellhousing is from a 77 maverick.
I'm not sure about the protruding hump. The shop is 3 hours from my house. I am headed down Monday and Tuesday to check it out though. What are you thinking?

TC

Alright... on a 302 swap the C4 is not working. I couldn't figure it out and a shop has had it for 2 months! The tranny has pressure when out of the B2, but when put in, it is not building pressure. Everything internal has been replaced several times, so they are thinking that it might be the ...

Good advice, thanks. I'll go with some decent mufflers, no glass packs. I assume you stuck with 3" on your conversion? The flowmaster setup sounds good.

The V8 is all in my 84 BII. I just need to build a bumper, hook up my shifter, and I am good to haul it down to the exhaust shop. Just wondering about opinions on what I should get. Reasonable price of course. I'm not going to spend $3000 on an exhaust that is 20 lbs lighter when I weigh 250. I'll ...

I did the 3". Lot's of room.
I have seen a 2wd Ranger with a 351, so, with enough cutting, anythings possible.

What's a tape?

Off topic...
I am coming through your neck of the woods on Monday 5/15. Wanna sell me that steering gearbox?

Check my wanted ad for my number and mail address.

No No! My caps might not make it as it is. 28 in July.
I CAN stay up past 10 though... lots of coffee.

Did someone bring the fire extinguisher?

52 I think.

...makes me hungry...

Rockcrawler could be right. Unfortunately I will never know. I took off the box. Used an air compressor to put pressure into the stem that the hydraulic line plugs into and almost got knocked out by the pitman arm. Something is stuck in there. Before I got back from the bathroom my old man had it ...