BroncoII4x4.com

I had the same problem with a few of mine on a 85 B2. Turned out the studs were stripped out thus allowing for the bi-directional spinning. Mine was caused by a combination of rust and cross threading(B2 had set for a few years waiting for a new engine). Have to hand start a lug nut before impacting ...

Well it turned out to be worse than I thought of course :puke:. After pulling the passenger side head, I not only found water in the cyclinder but a piston that was coming apart. Pieces along the edge were gone and a crack to the center of the piston. I tore down the rest of the engine and found a ...

I have two BII's, one an 85 and an 89. both had non-working fuel gauges when I got them. Thought it would be a sending unit until I pulled the tanks on both of them. Come to find out there was a hole in the brass float. I dried them real good and then soldered the holes shut. These are very thin and ...

Thanks for the info. About 3/4 of the way with the tear down now. Forgot how many odds and ins you have to take care to insure the rebuild goes back without problems. One question. There are two electrical connection going to the top of the thermostat housing. the smaller on with a single wire is ...

Alright, finally I have gotten outside and worked on the bronco. Here are the things I have found. First I found that my bottom radiator hose had a hole in it and very little water was left in the radiator. Very little oil was found under engine, no more than normal, so I have to assume the smoke ...

thanks, makes perfect sense, couldn't see the forest for the trees.

Hopefully easy question for someone. Trying to hook up 4 wire trailer hitch wiring. Each side has lime green wire, black wire and brown wire going to the turn signal/brake/tail light. Tried to buy after market kit, no such luck. Need advice on which wire is hooked to what on the 4 wire hitch(left ...

Looking for advice before I start on engine. Have 89 with rebuilt 2.9 engine with about 40-50K on it. Had new thicker casting heads put on engine when I installed rebuild. As this story goes, yesterday was driving onto freeway and accelerating when I heard a new clattering noise coming from the ...