BroncoII4x4.com

hey guys ....me again. Im having fuel issues on my 1989 2.9 efi it seems when it warms up it starts to studder. but i put the clutch in rev it up a couple times them im good for a nother few minutes. iv changed the filter twice now ut still acting up....now my bronco has had no exaust on it for a ...

hey I just got a luk gold put in at the shop .....havnt driven much but its alot better then the motomaster shit i had before

drill them out with a bit one size smaller then the olt it self then re-thread the hole or you can buy an easyout set... they go for roughly $25- $30

hey guys just looking for any tricks on replacing all the gears on the rear end i havnt done it before and not evan sure what any of its called all i know its in real rough shape

i had the same problem replaced thermostat flushed the rad system still not heating up...i bought a winter front put it on.....havnt had a problem since and its nice a nd toasty warm

ok awsome guys im just gonna get a new tranny and transfer case....is there any tricks or helpfull ideas for removing the old and puting in the new? how are the drive lines for holding up in this things? my pecker is bigger then my drive shaft.is there any after market ones that dont look like a ...

hey checked it all out im pretty sure its the transfer case the transmission is a manual and all the linkages were fine and a got some one to crawl underneath in the snow and he says its coming from the transfer case the noise so he decided the chain came off inside i thought it was a gear driven ...

if it is the transmission can that be replaced with out taking out the motor?

ok im getting it towed to a warm shop that i can look at it some more...its -47 with wind chill here a little to cold to be out mucking on a truck. Ill let you know what happens

hey Guys hope you can help......just bought a 89 bronco II XLT. i was recently driving down the road when the bronco jumped abit had a strange sound coming from transfercase of tranny......I stoped to check it out and linkage and everything was fine when i went to get going again it wound go into ...