I found this tread over at a FSB forum. the guy is running a stearing setup on the backof his axle. do y'all think this might work for coil sprung D44's? if it would it would eliminate the cause for the cheby knuckle conversion.
http://fullsizebronco.com/forum/showthread.php?t=17014
check this out....
check this out....
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...
http://www.catalystcycles.com
http://www.catalystcycles.com
-
- Posts: 160
- Joined: Mon Apr 26, 2004 2:49 am
- Location: Wichita, KS
- Contact:
-
- Posts: 588
- Joined: Sun Apr 18, 2004 10:41 pm
- Location: San Juan Bautista, CA
- Contact: