New driveshafts after 4" lift?
-
- Posts: 1
- Joined: Thu Oct 25, 2018 12:10 pm
- Location: Colorado Springs, CO
New driveshafts after 4" lift?
Brand new to the Forum. I have a 1986 B2. I just ordered a rough country 4" lift and I was wondering if ill need to modify or replace the driveshafts after install. Is there anything that ill need that the lift doesn't come with? other than extended brake lines of course.
Re: New driveshafts after 4" lift?
Standard or Automatic? Standard probably need the shifter extension. As far as driveshafts, I'm not sure. My 84 rear driveshaft actually had about 2 inches of play in it( telescoping ). Best bet is to check with the manufacturer and search other threads.
2013 Taurus SHO LMS V11 tune, 06 F150 Harley-Davidson Edition,03 Mustang GT Conv, 97 Jeep GC Laredo 5.2, 84 BII
-
- Posts: 4
- Joined: Wed Jan 31, 2024 6:12 am
- Location: UT
Re: New driveshafts after 4" lift?
I put a 4 inch lift on my 84. Driveline work great stock length.
-
- Posts: 14
- Joined: Fri May 27, 2022 11:51 am
- Location: oregon
Re: New driveshafts after 4" lift?
I’d go to the ranger station website and look at some of their tech articles as well as the b2 forum. Lots of archived info on lifting. Drive shaft angle, pitman arm length, front axle angle, etc. are all addressed.
Sounds fun, good luck!
Sounds fun, good luck!