My Wee Beasty
My Wee Beasty
This is the beginnign stage of the Bronco II Build
This is the day I brought it home. $500
Here is a new pict after the doors were cut, the body has been lifted 3 inches.
[/img]http://memimage.cardomain.net/member_im ... 8_full.jpg[/img]
Last edited by COWBOY6 on Wed May 18, 2005 10:30 am, edited 2 times in total.
New convertible added to the list
Here it is right after the roof came off.
tell me what you think.
I am still needing to cut the top of the door frame off. close the pillars, finish the windshield, and cage the whole rig. ALso need to add a support brace tot he rear quarter panel right behind the door to stiffen the wall.
Thanks for the look and the opinion
tell me what you think.
I am still needing to cut the top of the door frame off. close the pillars, finish the windshield, and cage the whole rig. ALso need to add a support brace tot he rear quarter panel right behind the door to stiffen the wall.
Thanks for the look and the opinion
You will need to support the windshield frame for sure. If cut the doors you should remove the door glass since there will be nothing to support those either. Looks like you will need a lift with those tires unless you cut the fenders too. Nice clean start though. Good luck!!
EBSteve just likes to watch me break things.:-)
420HP and 775Ft lbs Now it is time to break things.
420HP and 775Ft lbs Now it is time to break things.
definatly keep the pics comming, that was the next idea I had for mine. you will need a roll bar now, that is the only thing holding me back from getting out the swazaw again.
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...
http://www.catalystcycles.com
http://www.catalystcycles.com
The cage goes all the way tot he floor, and I am tying it to the frame
Send me an emso I can send attachments.
janshan3@earthlink.net
that is open to all that want picts of different stuff fromt he build.
I have picts of the doors, the cage the tire carrier, and soon the top.
Thanks,
James
Send me an emso I can send attachments.
janshan3@earthlink.net
that is open to all that want picts of different stuff fromt he build.
I have picts of the doors, the cage the tire carrier, and soon the top.
Thanks,
James