axle housing/bearing stud's

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
FatMan
Posts: 762
Joined: Sun Apr 18, 2004 10:26 pm
Location: Mt.Vernon, WA
Contact:

axle housing/bearing stud's

Post by FatMan »

does anyone know where i can get the 8 axle housing/bearing stud's besides a yard. i would like to get them new if at all possible.

thank's
Darker than your average wheeler!!!!
User avatar
Nobody
Posts: 2233
Joined: Sun Apr 18, 2004 6:38 pm
Location: Stanwood, WA.
Contact:

Post by Nobody »

Are you talking about the ford 9 inch bearing retainer studs at the ends of the axle tubes?

I'm not sure where to get them, but I think they should be pretty common. I'd try Napa. If not there, call any shop that builds axles, Randys, dutchman, moser, etc.....
DBrown
Posts: 1545
Joined: Mon Apr 19, 2004 5:21 am
Location: Bowling Green, KY

Post by DBrown »

I think you can get them from jeff's bronco graveyard also...
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...

http://www.catalystcycles.com
FatMan
Posts: 762
Joined: Sun Apr 18, 2004 10:26 pm
Location: Mt.Vernon, WA
Contact:

Post by FatMan »

yep that's what im looking for thank's fellas i'll call NAPA tommarrow and see if they have them.
Darker than your average wheeler!!!!
Post Reply