Re-gearing for 33×12.50 15 tires.

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
Whistler62
Posts: 4
Joined: Wed Jan 31, 2024 6:12 am
Location: UT

Re-gearing for 33×12.50 15 tires.

Post by Whistler62 »

I have a 1984 B2. 3.73 gears. I lifted ir 4 inches and put 33 inch tires on it. What is the preferred gear ratio for these tires? I rebuilt the 2.8 and went to the dura spark set up. New carb and no smog junk. Runs great. Just a little under powered now. Thanks for any help.
Dustin_Oregon
Posts: 14
Joined: Fri May 27, 2022 11:51 am
Location: oregon

Re: Re-gearing for 33×12.50 15 tires.

Post by Dustin_Oregon »

In terms of easily available ratios, I’d go with 4.10.
Check out the chart here for more detail. Cheers


Image

“ The chart is divided into three categories. The rpm highlighted in black are optimum for the tire size and ratio combination. These will most closely give you the best overall drivability. If you're looking for a ratio that will give better fuel economy for highway driving at the expense of some acceleration and overall performance, choose a ratio in the yellow shaded area. If you're looking for a ratio that will improve acceleration and towing power at the expense of some fuel economy, choose a ratio in the blue shaded area”.
Whistler62
Posts: 4
Joined: Wed Jan 31, 2024 6:12 am
Location: UT

Re: Re-gearing for 33×12.50 15 tires.

Post by Whistler62 »

Thanks for your help. I appreciate the pic of the chart. Very helpful.
Post Reply