4.0 Swap: Runs dies and VSS Wiring

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
ottoparts
Posts: 2
Joined: Sat Oct 22, 2022 6:27 pm
Location: NM

4.0 Swap: Runs dies and VSS Wiring

Post by ottoparts »

For the folks that have performed a 4.0 swap into their B2. Did you hook the VSS wires to the wiring from the transmission/transfercase or to the wiring coming out of the firewall?
I got my swap done, however it only runs for 30 seconds and then shuts off. Starts right back up, then dies again after 30 seconds. Any ideas?
Swap info: 94 Explorer 4.0, 91 Explorer wire harness, 88 B2.


Thank you
ottoparts
Posts: 2
Joined: Sat Oct 22, 2022 6:27 pm
Location: NM

Re: 4.0 Swap: Runs dies and VSS Wiring

Post by ottoparts »

fixed.
User avatar
tekatlarge
Posts: 986
Joined: Tue Jan 17, 2006 8:54 am
Location: Coastal, Worshington

Re: 4.0 Swap: Runs dies and VSS Wiring

Post by tekatlarge »

Glad to hear you got it fixed. Tell us what you found so if someone encounters similar circumstances, they will have an idea of what to check?
The Tek @ Large
Coastal,Worshington
Livin life on the dole on the Coast
Post Reply