Real world tips and tricks for the do-it-yourself ethusiast. Tools and parts that make life easy, and simple fabrication tips and tricks.
1 post • Page 1 of 1
well I ran into an issue while I was putting my radius arm drop brackets on I could not get the radius arms to pull in and go back at the same time, so two different directions to go but would not budge, so I had to improvise I used a ratchet binder with chain bolted at each end to pull them together evenly! so main highlight here is the ratchet binder! So I got them lined up could have not gone in the drop brackets better now this is being done with front steering components off and springs off, I got the radius arms into their brackets but would not go back far enough so that I could get their I believe 1 1/8 not threaded enough as to not strip it, could not get them to budge by hand or with a pry bar and bolt it down at the same time, soo I seen my john deere sitting their and thought I wounder how much force that mower could put on it and sure enough with radius arms in the bracket but not far enough back I lined the lawn mower tire up and superswamper up and bam went in perfectly!! NOTE don't forget to put the radius arm bushing on before doing any of this!
Who is online
Users browsing this forum: No registered users and 0 guests