Hi to all, just found a minty condition 84 Bronco II. I need to know how to remove the ingnition module from the back of the distributor. V6 engine, I can see the small screws (2) using a mirrior, I think they are 1/4 inch heads or smaller but I can't get a socket into the hole. Is there a special socket that will fit.?? Thanks to all who reply.
I am a new mwmber, will post my profile soon.
New to me
-
- Posts: 44
- Joined: Tue Dec 06, 2005 11:21 am
- Location: Eureka, MT
When you go to your local NAPA or what have you, and you buy the new module ask them for the tool needed for the install. They will hand you a plastic faucet handle shaped thing with a socket imbedded or a 5.5 MM socket head for 1/4 drive, either will work. They may let you borrow the tool or the selling pirce is usually less than $5.