replacing dana 28

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
stupidcow79
Posts: 29
Joined: Tue Apr 25, 2006 9:27 pm
Location: Puyallup, wa
Contact:
Contact stupidcow79

replacing dana 28

Post by stupidcow79 »

hey broke my slip yoke off my u joint on my dana 28 everything is stock but yah i have a parts bronco it is an 84 with a dana 28. anything i should no about when taking off both axles and replacing it?
Top
User avatar
tekatlarge
Posts: 992
Joined: Tue Jan 17, 2006 8:54 am
Location: Coastal, Worshington

Post by tekatlarge »

My only advice is to buy a Big box of Band-aides and a rack a beer!
The Tek @ Large
Coastal,Worshington
Livin life on the dole on the Coast
Top
ranger5.0
Posts: 743
Joined: Sat Jan 01, 2005 8:10 pm
Location: Granite Falls, Wa
Contact:
Contact ranger5.0

Post by ranger5.0 »

I have found that 83 and 84's with automatics have different drivelines than newer models. The ones I have had, used a fullsize u-joint at both ends. Diffinetly stronger.
EBSteve just likes to watch me break things.:-)
420HP and 775Ft lbs Now it is time to break things.
Top
stupidcow79
Posts: 29
Joined: Tue Apr 25, 2006 9:27 pm
Location: Puyallup, wa
Contact:
Contact stupidcow79

reply

Post by stupidcow79 »

yah its a manual tranny but i hope its i little bit stronger then then the 88's
Top
Post Reply

Return to “Bronco Tech”