Creative use of a drill press

Real world tips and tricks for the do-it-yourself ethusiast. Tools and parts that make life easy, and simple fabrication tips and tricks.
Post Reply
User avatar
Nobody
Posts: 2216
Joined: Sun Apr 18, 2004 6:38 pm
Location: Stanwood, WA.
Contact:

Creative use of a drill press

Post by Nobody »

This is a trick I learned from EBSTEVE. Attach a cutoff wheel to an arbor, and you have an instant milling machine...well not quite. For the most part it works very well. I did find I get a little bit of deflection on the cutoff wheel, but after it wore down a bit, it worked better.

Image
User avatar
tekatlarge
Posts: 983
Joined: Tue Jan 17, 2006 8:54 am
Location: Coastal, Worshington

Post by tekatlarge »

That is a good suggestion there Nobody.

I used to use that same approach approach Untill I finally bought a Mill.

Here is a very cheep way to improve on the drill press mill.

for a mere 40 bucks you can get a machinists cross slide vise that you can crank back and forth like a (mini) mill table. The vise gets secured to the drill table and you feed the part in by cranking the handles. Check out this vice at Harbor Fright!! :eek: http://www.harborfreight.com/cpi/ctaf/d ... number=538

For 40 bucks you have basically a milling machine. Next step would be to buy a couple of end mills and away you go.
The Tek @ Large
Coastal,Worshington
Livin life on the dole on the Coast
dgl6y6
Posts: 84
Joined: Wed Jul 22, 2009 8:56 am
Location: St. Louis

Re: Creative use of a drill press

Post by dgl6y6 »

Could you add in a fender washer above the cutoff wheel to cut down on deflection?
Lance Skene
Posts: 144
Joined: Fri Dec 27, 2013 8:06 am
Location: Calgary Alberta

Re: Creative use of a drill press

Post by Lance Skene »

I buy router bits made for use with steel and aluminum, since they are designed with cutting edges on the side of the bit they work very well with a cross slide vise.
'80 Bronco 351M
'85 BII 2.8/Duraspark
'89 F150 302 Supercab
Post Reply