fabrication on frame

What's new? Come on in and get to know the other Bronco II enthusiasts on the Forum.
Post Reply
Posts: 1
Joined: Wed Oct 07, 2015 7:17 am
Location: idaho

fabrication on frame

Post by vvp » Wed Oct 07, 2015 7:47 am

hello this is vvp. I am putting a ranger cab onto a bronco2 frame.my question is what is the trick for the rear cab mounts. does anyone have photos of this process and or and helpful advice? thanks for your time. vvp

User avatar
Posts: 977
Joined: Tue Jan 17, 2006 8:54 am
Location: Kent, Worshington

Re: fabrication on frame

Post by tekatlarge » Fri Oct 09, 2015 7:54 pm

I have seen a thread here a long time ago about someone doing what you are asking about. I remember the rear mount was something built up on each frame rail with a cross member going across the right under the back of the cab.

You might want to do a search here on that subject.
The Tek @ Large
I was borne under a rock. So what's your excuse?

Post Reply