U joint question...

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
User avatar
PHROX
Posts: 95
Joined: Wed Apr 28, 2004 3:01 pm
Location: salt Lake City
Contact:

U joint question...

Post by PHROX »

on my d44 I just blew out the berings on the drivers side u joint. is it possible to switch out the u joint without removing the axel shaft?
1987 Bronco2, d44/9" locked, sweet paint job. Now with available 5.0
User avatar
Nobody
Posts: 2232
Joined: Sun Apr 18, 2004 6:38 pm
Location: Stanwood, WA.
Contact:

Post by Nobody »

No.

It only takes about 10 minutes to pull a shaft anyway.
User avatar
PHROX
Posts: 95
Joined: Wed Apr 28, 2004 3:01 pm
Location: salt Lake City
Contact:

Post by PHROX »

rats, I seem to have bad luck when pulling axel shafts, but oh well
1987 Bronco2, d44/9" locked, sweet paint job. Now with available 5.0
Post Reply