correct pinion angle

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
NMB2
Posts: 128
Joined: Tue Feb 08, 2005 11:39 pm
Location: Albuquerque, New Mexico
Contact:
Contact NMB2

correct pinion angle

Post by NMB2 »

ok im doing my 8" axle swap and ive just got the perches welded on...the only thing i did take into consideration is the lift shackles, i setup the pinion/d-shaft pointing straight at eachother so at full hang they are straight. then i put in the 2" lift shackles and it set it off just a little bit...it'll go back to just about straight i imagine once the truck sits on itself. is that pinion angle alright or am i going to break something?
i wish my lawn was emo...so it'd cut itself.
Top
Post Reply

Return to “Bronco Tech”