89 bronco 2 engine light stays on, and unable to pull codes.
Posted: Wed Jan 22, 2020 8:28 pm
Good evening everyone,
I have a 89 bronco 2 with the 2.9. I have been having starting problems with since I purchased the vehicle. I have replaced the map,iac,tps, intake manifold temp sensor, icm,new distributer cap, wires, and spark plugs. New battery cables, starter relay, upper intake gaskets, valve cover gaskets. That's a little back into on installed and tried. I have a constant engine light that wont go off. I have tried leaving the battery disconnected to reset computer but no hopes. I am unable to pull codes no matter how I try cause of the constant light. One other thing the full pump runs constantly with key on. Anything will be helpful to possibly get this fixed.
Thanks for help.
I have a 89 bronco 2 with the 2.9. I have been having starting problems with since I purchased the vehicle. I have replaced the map,iac,tps, intake manifold temp sensor, icm,new distributer cap, wires, and spark plugs. New battery cables, starter relay, upper intake gaskets, valve cover gaskets. That's a little back into on installed and tried. I have a constant engine light that wont go off. I have tried leaving the battery disconnected to reset computer but no hopes. I am unable to pull codes no matter how I try cause of the constant light. One other thing the full pump runs constantly with key on. Anything will be helpful to possibly get this fixed.
Thanks for help.