New driveshafts after 4" lift?

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
Posts: 1
Joined: Thu Oct 25, 2018 12:10 pm
Location: Colorado Springs, CO

New driveshafts after 4" lift?

Post by alaskan4X4 »

Brand new to the Forum. I have a 1986 B2. I just ordered a rough country 4" lift and I was wondering if ill need to modify or replace the driveshafts after install. Is there anything that ill need that the lift doesn't come with? other than extended brake lines of course.
Posts: 75
Joined: Tue Aug 18, 2009 1:12 pm
Location: FT. Hood, TX.

Re: New driveshafts after 4" lift?

Post by broncofan »

Standard or Automatic? Standard probably need the shifter extension. As far as driveshafts, I'm not sure. My 84 rear driveshaft actually had about 2 inches of play in it( telescoping ). Best bet is to check with the manufacturer and search other threads.
2013 Taurus SHO LMS V11 tune, 06 F150 Harley-Davidson Edition,03 Mustang GT Conv, 97 Jeep GC Laredo 5.2, 84 BII
Post Reply