88 Bronco II Flywheel

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
Posts: 1
Joined: Tue May 02, 2017 11:19 am
Location: Kenova, WV

88 Bronco II Flywheel

Post by skag1011 » Tue May 02, 2017 11:27 am

Got an 88 Bronco II, auto trans, 4WD. Having problems with the flywheel breaking. The last one didnt last a year. Any recommendations on where to buy a good quality flywheel? Also, I have found them with 138 teeth and 141 teeth. Which should I use? Any help is greatly appreciated.


User avatar
Posts: 969
Joined: Tue Jan 17, 2006 8:54 am
Location: Kent, Worshington

Re: 88 Bronco II Flywheel

Post by tekatlarge » Wed May 03, 2017 7:32 pm

I am not sure which one you need. Where are the flex plates breaking at the center or on the outside edge. There are several reasons flywheels break. My Expierence is with breaking or cracking at the crankshaft bolts then it could be un balanced converter, A worn bushing in the front of the trans can cause converter wobble. Breaking near the starter ring is usually a sign of a mis aligned starter. :cool:
The Tek @ Large
I was borne under a rock. So what's your excuse?

Post Reply