B2 vent windows

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Posts: 2
Joined: Fri May 30, 2014 5:05 pm
Location: Lubbock,Texas

B2 vent windows

Postby OlFordman38 » Fri May 30, 2014 5:12 pm

What parts are needed to remove vent window and install a one piece glass?

User avatar
Posts: 961
Joined: Tue Jan 17, 2006 8:54 am
Location: Kent, Worshington

Re: B2 vent windows

Postby tekatlarge » Sat May 31, 2014 12:26 pm

I never tried to remove the vent window and replace with a one piece, However Just thinking you are going to need the window channel and window from a donor door. You may have to replace the window raising and lowering hardware but you may be lucky and be able to use your current hardware.

Another way to do it would be to pick up a couple of doors with the one piece window and just swap doors.

Just saying
The Tek @ Large
I was borne under a rock. So what's your excuse?

Slammin Sam
Posts: 8
Joined: Tue Oct 15, 2013 2:29 pm
Location: fruita, co

Re: B2 vent windows

Postby Slammin Sam » Mon Jun 09, 2014 1:09 pm

I agree with tekatlarge, swap the doors, unless your original doors are rust free and have great paint. Many guys with the 89/90 B2s would rather have the vent wings.

User avatar
Posts: 2
Joined: Wed Jul 23, 2014 3:23 pm
Location: Plainfield, Connecticut

Re: B2 vent windows

Postby Captainstubs1 » Wed Jul 23, 2014 3:46 pm

Yea if you are swapping I'll take the vent window equipment if you're looking to sell.

Return to “Bronco Tech”

Who is online

Users browsing this forum: No registered users and 2 guests