Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
3 posts • Page 1 of 1
I'm trying to replace a busted flywheel. I've never pulled the tranny before. I need to find out if I have to remove the cross member that holds the radius arms in place and if I have to remove the "y" pipe. Both of these run directly under the bell housing and there is hardly any clearance with them in place. If I have to remove the cross member, is there tension on the radius arms? I dont want to remove more than needed, and I dont want the front end to collapse on me if I take the wrong thing loose. Please help. Thank you.
The cross member stays, remove the y-pipe
Didn't look like there was room to get the y pipe out without removing the cross member but I will sure give it a try. Thanks.
Who is online
Users browsing this forum: No registered users and 1 guest