Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
4 posts • Page 1 of 1
I just noticed that my transmission support brace is starting to rust through.( 88 b2 4x4)I'm having trouble finding any where to buy a new 1. Local junk yards don't have anything better than what I have now. it's rusting through on the tube that contains the rubber bushing. I've noticed on full size Broncos another Ford trucks there is only a rubber bushing between the transmission and the brace, the brace bolts directly to the frame. I'm thinking it might try to fabricate a new brace and bolt it directly to the frame in this fashion. trying to fabricate a new brace to replace the factory 1 is a bit out of my league. Anybody have any thoughts?
I was looking at one of those higher dollar built rigs last night. It was built using one of the earlier or ranger crossmembers. One bracket is factory riveted to the frame and has a bolt at the bottom and bolts to the frame on the other side. When mine gets real bad, I will pull the one I got from my old ranger.
Hey i Know this is an old thread but i thought id update it in case anyone is looking. I found a bunch of places selling brand new ford oem replacements for the whole crossmember for around 150. I was about to pay a machine shop to turn down an over sized urethane bushing to replace the bushings in the junkyard one i got after i started this thread back in '09. It was hard to find because its referred to as "rear engine mount bracket" ??? but the part number is "E9TZ6A023E" A quick google search of the part number came up with a bunch of hits. Sorry it took almost 3 years to find guys, I hope nobody gave up.
Who is online
Users browsing this forum: No registered users and 1 guest