BII with 4.0 and headers

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Posts: 1
Joined: Wed Apr 18, 2012 5:56 pm
Location: georgia

BII with 4.0 and headers

Postby Truckerdawg » Wed Apr 18, 2012 6:08 pm

I have unsuccessfully googled my subject line trying to find out if and or which headers might fit a '90 4X4 BII with a 90-94 4.0L engine. Or is this an almost impossibility without a lot of fabrication. I think the 90-94 ranger/explorer 4.0 used the same header- so would this header fit easily into the engine compartment on both sides? Does anybody have this combo? Thanks for any input. I have the 5 spd manual tranny.

Return to “Bronco Tech”

Who is online

Users browsing this forum: No registered users and 1 guest