Receiver Hitch / Winch mount

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
SmokeEater829
Posts: 9
Joined: Mon Dec 12, 2011 4:44 am
Location: New Orleans, LA

Receiver Hitch / Winch mount

Post by SmokeEater829 »

I just got my first B2. I'd like to put receiver hitches in front and back on it. I want to be able to move my multi mount winch from my daily driver over to the B2 during hunting season when I use it the Bronco. I have found a few rear hitches, but have not found a front mount yet. Can anyone tell me where to look, or am I gonna have to fab one myself?

Thanks
dgl6y6
Posts: 84
Joined: Wed Jul 22, 2009 8:56 am
Location: St. Louis

Re: Receiver Hitch / Winch mount

Post by dgl6y6 »

frame should be the same width on front and back. measure to be sure then just get 2 of the same hitches. you might have to drill into the frame. i drilled to put in tow hooks, it took a while and i got covered in wd 40 but its possible. the bumper doesnt sit much lower than the frame so it should work out pretty good. the plastic air dam thing has to go but it looks like crap anyway. i hate plastic on trucks
Post Reply