I need a little help with remembering how the wiring harness is run from the dash to the center consel on my 86 Bronco II. The harness drops down to a plastic clip on the trans tunnel. Then it has two etal platesonnected on it ithat get screwed to the ?. Then there is another plastice clip after the gear shilt lever. Does the harnes run on the passenger side or the drivers side? Does it screw to the trans tunnel? I can't find any screw holes and I cant' remember. Anyone know or have a picture?
Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests