transfer case recommendations?

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
DBrown
Posts: 1545
Joined: Mon Apr 19, 2004 5:21 am
Location: Bowling Green, KY

Re: transfer case recommendations?

Post by DBrown » Tue Mar 29, 2011 10:22 am

the D28 will not handle those tire sizes. if you wan't to run 38-40's you realy need to have either a built D44/9" combo or D60/14bolt combo. this will involve you doing a solid axle swap.
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...

http://www.catalystcycles.com

101btp
Posts: 120
Joined: Mon Mar 02, 2009 7:25 am

Re: transfer case recommendations?

Post by 101btp » Tue Mar 29, 2011 11:25 am

alright well right now it's on 32" super swappers but i think over the winter of doing a good sized swap like that

DBrown
Posts: 1545
Joined: Mon Apr 19, 2004 5:21 am
Location: Bowling Green, KY

Re: transfer case recommendations?

Post by DBrown » Wed Mar 30, 2011 5:01 pm

yeah, you need to put some time asside for that man...I am realy busy and I am in month 10 of mine. it sucks, its on its own weight but not movable. The ranger one is a little more straight forward then what I am doing though...read up on Nobodys swap. I think he did his in a weekend.
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...

http://www.catalystcycles.com

Post Reply