Rear liftgate Parts

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Posts: 1
Joined: Thu Jan 06, 2011 3:58 am
Location: Petersburg, VA

Rear liftgate Parts

Postby vpisu4ever » Thu Jan 06, 2011 4:07 am

Hello, I recently purchased a 1984 Ford Bronco II, what a great truck! I need the internal parts and handle for the rear liftgate. I have tried local junk yards, no luck. Any suggestions where ,online or not, I may be able to find these items. Thanks

Cornhusker Brute
Posts: 18
Joined: Sun Aug 09, 2009 7:22 am

Re: Rear liftgate Parts

Postby Cornhusker Brute » Sun Jan 09, 2011 4:13 pm

I might have what ya need. Email me and we can chat.

Posts: 8
Joined: Tue Feb 12, 2013 3:56 pm
Location: California

Re: Rear liftgate Parts

Postby Gerry » Fri Feb 15, 2013 11:01 pm

A few years back I had to deal with a broken lift gate handle on my 90 EB BII--seems the design sort of allows you to turn it the wrong way even though there's a little arrow directing you to turn it to the right. To make matters worse the designers made that same handle the only one that you can apparently lift open the gate with so over time the wear and tear just takes its toll. I couldn't find a new parts supplier for this so I went online to a site that takes your info and puts it out to hundreds of wrecking yards all over the country. I heard back from several and finally chose one who shipped the whole mechanism to me. I installed it and it's still working fine; however, I am very gentle with it--turning it correctly then lifting the gate from the bottom, not with the handle.

Return to “Bronco Tech”

Who is online

Users browsing this forum: No registered users and 1 guest