I have a 2,9 1990 Bronco II. If i have the 4x4 activated and turn off the ignition it gets stuck in 4x4 mode and wont release until i get under the car and take out the transfer case motor and turn it manually. If i unactivate the 4x4 before turning off the car it works. Its electrical 4x4.Could it be the transfer case motor?
Best regards: Andreas from Finland
Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest