Engine swap compatibility

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
KFarr
Posts: 3
Joined: Fri May 22, 2009 8:07 am
Location: Wenatchee, WA
Contact:

Engine swap compatibility

Post by KFarr » Thu Aug 19, 2010 11:49 pm

There's a 98 Ranger that someone is parting out on CL in my area. They are wanting to part it out, so I'm trying to trade him a bunch of electronics I have laying around for the motor and thew hole wire harness.

If it's either a 2.9 or 4.0, will it still bolt up to my 5spd (4spd w/ OD) trans in my 85 Bronco II? Manual everything, has the 2.8l in it right now.

If the donor truck has an auto, I should only need to get a manual ECU right? I'd like to keep my trans, since the truck oinly has 122k on it.

Thanks for reading guys

Post Reply