85 BII- Floor Panels/Engine

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Posts: 1
Joined: Sun Aug 08, 2010 7:48 pm
Location: Georgia

85 BII- Floor Panels/Engine

Postby BroncoIIDrew » Sun Aug 08, 2010 7:56 pm

My floor panels and rear floors are starting to rust out. what would be the best thing to do to fix them? i can weld but idk if that would be best or to just get a new uni-body.

And my engine seems to run rich. i tuned it a while back. ive turned it till the gauge hit 15.5 then it started goin back down but it still seems to run rich not as bad but still bad. My friends dad said it could be that one of my cylinders could not be firing. what does everyone else think?

Return to “Bronco Tech”

Who is online

Users browsing this forum: Google [Bot] and 1 guest