My work is getting rid of 5 20 foot sticks of 1.5" square tube steel and a bunch of misc lengths. I am going to use this to build a RTI ramp. I have it all planned out at 25 degrees. I was going to go 2 feet wide but I am thinking of going a little smaller. Tomorrow it gets cut and then it just needs welded. I don't plan on using this to actually get my RTI number, but more of a tool for checking what kind of travel I need out of my shocks and where to place my bump stops. If you want pics of the progress let me know. If not I'll post them when I get done. I won't start welding for a few weeks though. I got to get the truck fixed up first.
Hey, it's free so why not?
*Wasn't sure where this should be posted.
Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest