84 bro2 engine swap

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
Falec70
Posts: 7
Joined: Wed May 12, 2010 12:49 pm
Location: Tennessee

84 bro2 engine swap

Post by Falec70 » Wed May 12, 2010 12:58 pm

are there any larger engine that i could swap to without changing the transmission?

Falec70
Posts: 7
Joined: Wed May 12, 2010 12:49 pm
Location: Tennessee

Re: 84 bro2 engine swap

Post by Falec70 » Wed May 12, 2010 2:23 pm

what engines and transmissions would fit

User avatar
tekatlarge
Posts: 969
Joined: Tue Jan 17, 2006 8:54 am
Location: Kent, Worshington

Re: 84 bro2 engine swap

Post by tekatlarge » Wed May 12, 2010 4:39 pm

A 4.0 explorer motor and trans and diffs will all bolt right into your rig. the 4.0 will bolt up to the stock b2 trans. you would need to use the explorer computer and do some wiring but that is the the only real way to get more power with out dropping in a 5.0 or 351.
The Tek @ Large
Kent,Worshington
I was borne under a rock. So what's your excuse?

Falec70
Posts: 7
Joined: Wed May 12, 2010 12:49 pm
Location: Tennessee

Re: 84 bro2 engine swap

Post by Falec70 » Wed May 12, 2010 4:49 pm

so i could just use the motor off of the explorer. what would i have to buy

awjuhl
Posts: 6
Joined: Mon May 03, 2010 7:33 am
Location: Lima, ohio

Re: 84 bro2 engine swap

Post by awjuhl » Sun Jul 11, 2010 1:05 am

Do you know if the wire loom would work that is already in a 88 work to a sertain extent for a 4.0

Post Reply