cut and turn ttb axles

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
tickturd
Posts: 15
Joined: Mon Feb 15, 2010 1:49 pm
Location: Hanover minnesota

cut and turn ttb axles

Post by tickturd »

how is this done, i have a pretty good idea, but i was wondering is, how do you figure how far to bend the cut. i was wondering also if it could be done while it is still under the truck if supported by stands and a floor jack to stop it when the desired tire angle is found. or am i just an idiot
Post Reply