Problem with Body Lift

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
Dieselmech52
Posts: 8
Joined: Fri Feb 22, 2008 10:11 am
Location: New Haven, Kentucky

Problem with Body Lift

Post by Dieselmech52 »

Well, here's the story. I am in the middle of a 2" body lift on my 85 B2 so I can clear my new 31x10.50 treadwrights and ran into a little problem. I ordered new urethane body mounts but they did not come with the steel sleeve that goes through the middle of them. So now my bronco is another lawn ornament until I can get some sleeves. Can you order them or would I be better off trying fastenall or a hardware store.
Im thinking now I should have went with a suspension lift.
Dieselmech52
Posts: 8
Joined: Fri Feb 22, 2008 10:11 am
Location: New Haven, Kentucky

Re: Problem with Body Lift

Post by Dieselmech52 »

LMC truck wants 20 bucks a piece for them. Thats not going to happen. What has everyone else used. Do I have the only bronco with a little bit of rust or what???
tickturd
Posts: 15
Joined: Mon Feb 15, 2010 1:49 pm
Location: Hanover minnesota

Re: Problem with Body Lift

Post by tickturd »

why dont you try getting some conduit from the electrical dept at the home depot and make your own sleeve, im not sure what the crush strength is but i bet it will work
Post Reply