Got codes, now what should I do?

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
bump2bii

Got codes, now what should I do?

Post by bump2bii »

I just ran codes on my 86 BII and here's what it gave me:

CM - 14, 18, 22

What should I check first? Ignition module's what I was thinking, but not sure.
FatMan
Posts: 762
Joined: Sun Apr 18, 2004 10:26 pm
Location: Mt.Vernon, WA
Contact:

Post by FatMan »

what is the problem with your rig?
Darker than your average wheeler!!!!
Bump2bii

Post by Bump2bii »

I'll give you a link that has a disscusion already started about it, better then re-typing everything.

http://www.therangerstation.com/forums/ ... 834#130834
FatMan
Posts: 762
Joined: Sun Apr 18, 2004 10:26 pm
Location: Mt.Vernon, WA
Contact:

Post by FatMan »

well sound's like your getting some good advice over there. one thing i would do is check your timing.

for some reason my truck lost power when i moved to CA, from WA. it would drive fine around town but would lose power on the highway especially noticeable going up little hill's. on a trip to Southern CA i pulled over and advanced the timing and she ran like a champ never had a problem sense. i still have to check my timing it's on my list of thing's to do.
MrShorty is right too about the T.F.I failing those thing's heat up and crap on you. if you can check it go for it . i replaced mine becuz i suspected it to be the reason i was losing power while towing my wifes car to CA.
Darker than your average wheeler!!!!
Post Reply