hp & torque on '87 302?
hp & torque on '87 302?
Anyone know the r.p.m.s at which the '87 f-150/bronco 302 puts out ? hp & ?torque? Been looking all over the net.
is it an HO motor or just EFI?
it should be around 215 if non HO
should be around 225 or 245 if it is an HO, can't remember?
I think thats what I was told by a mustang guy one time......
I do know their was a few years they had a "hot" setup in the intake and electronics, but I am not sure if it carried over into the trucks or not. I think it was in the 87 mustang.....
if you get a FI motor I would go for the mass air motor or one that has be upgraded to mass air. oh, and that motor has a 50oz. balance so you know what flywheel to get.
as far as the RPM I would think low like around 1700-2400, but I have not looked at any numbers so double check me on that.
it should be around 215 if non HO
should be around 225 or 245 if it is an HO, can't remember?
I think thats what I was told by a mustang guy one time......
I do know their was a few years they had a "hot" setup in the intake and electronics, but I am not sure if it carried over into the trucks or not. I think it was in the 87 mustang.....
if you get a FI motor I would go for the mass air motor or one that has be upgraded to mass air. oh, and that motor has a 50oz. balance so you know what flywheel to get.
as far as the RPM I would think low like around 1700-2400, but I have not looked at any numbers so double check me on that.
71 Bronco - twin sticked, full width, 2" lift, wristed arm, lots of rust...
http://www.catalystcycles.com
http://www.catalystcycles.com
-
- Posts: 588
- Joined: Sun Apr 18, 2004 10:41 pm
- Location: San Juan Bautista, CA
- Contact: