i have a 84 BII 2.8 motor was runniing really rough. finally had to have the carb rebuilt. think i put all the lines back on right but it idled really high. i'm hoping someone has a readable diagram so i can make sure. any help would be appreciated. i looked in the chiltons manual and they look right.
but it was really smoking bad and idle screw was all the way back. might be time for the v8 swap
Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests