BII lift kits, drive shafts

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
OBXFHB
Posts: 28
Joined: Tue May 19, 2009 10:55 am

BII lift kits, drive shafts

Post by OBXFHB »

Hey everybody i need a little help. i just got my first bronco II and im ready to jack er up. But first i need a new drive shaft. from what iv read i should go with the u joints and not the same driveshaft withs CVs. where would i find one. what type of vehicle has that drive shaft. as far as a lift i think i need to get the leaf springs and coil springs from a explorer to start. that will give me 3.5" lift corrrect? Help me out i got plans for this beater. bed liner inside and out, chop top, snorkel, roll bars, I NEED MORE LIFT. Thanks, ANDREW
Post Reply