Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
3" leaf spring questions...
Replies: 3
by
Phillippi »
Thu Jun 24, 2004 5:24 pm
Ok I may be retarded, but I had a thought. When using 3" springs from a FS bronco, is it possible to cut 1/4" off either side of the eyes so it will...
3 Replies
3161 Views
Last post by Bronco19
Sun Jun 27, 2004 10:17 am
Pix/ideas for shock mounts
Replies: 7
by
TNMAN »
Wed Jun 02, 2004 2:49 am
The BroIII is almost complete. I need to put some shocks on the front and was wondering if anyone had any ideas or photos of shock mounting/brackets...
7 Replies
4801 Views
Last post by b2binbad
Sat Jun 19, 2004 11:34 pm
ranger leafs
Replies: 2
by
Rockcrawler »
Wed Jun 16, 2004 11:34 pm
Ok my leafs are about all but gone! to much flex! well i have two rangers just sitting here for me to pull parts off of and was wondering if the...
2 Replies
2480 Views
Last post by TNMAN
Thu Jun 17, 2004 2:44 am
shackle flip
Replies: 6
by
FatMan »
Sun Jun 06, 2004 9:55 pm
hey nobody what kind of hanger did you use to do your shackle flip? i checked the shop talk but did'nt see any write up on it. :hmmm:
6 Replies
4509 Views
Last post by FatMan
Wed Jun 16, 2004 12:14 am
T-case shifter installation woes
by
Bronco19 »
Mon Jun 14, 2004 7:23 pm
I installed the T-case, a BW1350 in my 89' 2wd B2. Everything is fine exept, the shifter when shifted to 2wd loses the lever out of reach and can't...
0 Replies
3859 Views
Last post by Bronco19
Mon Jun 14, 2004 7:23 pm
Is anyone using come-alongs?
Replies: 8
by
Bronco19 »
Mon Jun 07, 2004 4:01 pm
I was wondering if anyone is using a come-along to retrieve a stuck vehicle from mud or sand. I want to get a real good one, but don't know what...
8 Replies
6120 Views
Last post by Nobody
Sat Jun 12, 2004 8:56 pm
Swap a 4wd T-case in my 2wd B2 TODAY!
Replies: 4
by
Bronco19 »
Sun Jun 06, 2004 8:13 pm
That's right. I'm finally moving foward again. Got a BW1350 manual shift from a Ranger and installed it in my B2. It's still 2wd for now, but I got...
4 Replies
3425 Views
Last post by Bronco19
Thu Jun 10, 2004 8:36 pm
Taurus Fan
Replies: 11
by
MHHodges11 »
Fri Jun 04, 2004 9:42 pm
Just a quick comment on the taurus fan talked about in the Shop Talk section. I was interested since I want to go to an electric fan. I did some...
11 Replies
7640 Views
Last post by plowboy
Wed Jun 09, 2004 4:34 pm
NP435 goof?????
Replies: 6
by
DBrown »
Mon Jun 07, 2004 6:00 pm
ok, this is messed up. I pulled my NP435 out of my 79 today to swap in the 68 NP435 I had at a friends house.......they are different :hmmm:
6 Replies
3898 Views
Last post by DBrown
Tue Jun 08, 2004 8:08 am
D21/D20 adaptor?
Replies: 1
by
DBrown »
Mon Jun 07, 2004 7:19 pm
I was looking at the main page that the D21 adaptor......I am guessing that the 21 adaptor wouldn't work because the gear that pulls the front...
1 Replies
1947 Views
Last post by Nobody
Mon Jun 07, 2004 8:17 pm
60s
Replies: 9
by
wilber »
Wed May 26, 2004 6:49 pm
i thought someone on here had a 60 in a b2, and it was coil sprung.
9 Replies
6410 Views
Last post by MUD1986
Sat Jun 05, 2004 7:50 pm
np435 hydro clutch
Replies: 3
by
wilber »
Sun May 30, 2004 2:08 pm
finaly got it in and the slave on, i belive its all from a 79, ill have to check with alx to make sure.
3 Replies
3020 Views
Last post by wilber
Wed Jun 02, 2004 5:33 pm
D44 and 9" from a 79 ford
Replies: 22
by
Phillippi »
Sat May 01, 2004 6:28 pm
how does $300 for the set sound for FS Dana 44 disc and 9" rear? I have a guy near me that is selling these and he says they are in good shape....
22 Replies
16259 Views
Last post by wilber
Sat May 29, 2004 3:13 pm
NP435 problem
Replies: 3
by
DBrown »
Wed May 26, 2004 5:13 pm
I got the motor running on the 79, but when I started to mess with the tranny I ran into a problem. all the forward gears work fine, but when you put...
3 Replies
3161 Views
Last post by DBrown
Wed May 26, 2004 6:55 pm
Fm145? Fm146?
by
Wicked Bronco II »
Wed May 26, 2004 3:06 pm
Other than the 145 is 4wd only and 146 is 2wd and 4wd are there any differances between the two?.. which is better?? Thanks for the input
0 Replies
3759 Views
Last post by Wicked Bronco II
Wed May 26, 2004 3:06 pm
thought of this today...
Replies: 5
by
DBrown »
Sun May 23, 2004 10:37 pm
I was thinking of ways to set up my rear suspension today and I thought I would run this by y'all.
5 Replies
4375 Views
Last post by Rockcrawler
Wed May 26, 2004 12:48 pm
fuel prblems???
Replies: 12
by
huffs »
Fri May 14, 2004 10:09 pm
My truck is an 86 bronco2 with a 2.9l 4speed with od. my problem is kinda wierd. If i start up the truck and let it idle it will start with high idle...
12 Replies
7326 Views
Last post by huffs
Wed May 26, 2004 3:52 am
whats under this
Replies: 1
by
madmark »
Tue May 25, 2004 9:30 pm
HI evrybody
1 Replies
1946 Views
Last post by Nobody
Tue May 25, 2004 10:00 pm
got my locker.
Replies: 4
by
PHROX »
Mon May 24, 2004 8:08 am
yep, got my locker and 5.13 gears in, the handling is very different, I was just wondering if you guys running lockers also got wierd handling. I am...
4 Replies
3080 Views
Last post by PHROX
Tue May 25, 2004 4:22 pm
ECM Wiring
Replies: 1
by
MHHodges11 »
Tue May 25, 2004 8:37 am
Does anyone know where I can find a wiring schematic for an ECM computer in an 84B2. My project has only one of the o2 sensors wired in and I need to...
1 Replies
2229 Views
Last post by DBrown
Tue May 25, 2004 3:09 pm
rear driveshaft trouble!
Replies: 13
by
MXjunk127 »
Wed Apr 21, 2004 5:22 pm
Well, My Broncs rear driveshaft broke into a whole lot of peices. I think Its because when the previous owner put the lift on it, The driveshaft did...
13 Replies
10051 Views
Last post by unfknreal
Tue May 25, 2004 9:15 am
What to do first?
Replies: 8
by
Bronco19 »
Sat May 22, 2004 4:47 pm
I'm a little unsure exactly what I should do first. I'm wanting to hit the trails and not look like a total idiot. Right now I have 33/12.5" street...
8 Replies
5660 Views
Last post by Phillippi
Mon May 24, 2004 6:42 pm
Does Dana 35 off Explorer work on 89B2?
Replies: 30
by Bronco19 » Wed May 12, 2004 11:10 am
Does anyone know for sure if a Dana 35 from a 91'-94' Explorer is a direct swap for my 89' 2wd B2? I've heard something about the pivot brackets...
30 Replies
24928 Views
Last post by bigswede
Mon May 24, 2004 3:47 pm
2 Replies
2813 Views
Last post by DBrown
Sun May 23, 2004 9:14 pm
Swamp_DonKey Trouble! How to hot wire a 2.9
Replies: 3
by vj_M » Fri May 07, 2004 4:58 pm
How can i hot wire a 2.9
3 Replies
2775 Views
Last post by VJ_M
Thu May 20, 2004 4:50 pm
headers
Replies: 2
by
808 bronco »
Sat May 01, 2004 11:18 am
hey fellow broncees,
2 Replies
3058 Views
Last post by Guest
Wed May 19, 2004 11:37 am
wristed arm question's
Replies: 11
by
FatMan »
Sun May 02, 2004 3:06 pm
okay, okay, okay :D
11 Replies
7442 Views
Last post by FatMan
Mon May 17, 2004 9:31 pm
Leaking gas problems
Replies: 7
by Visitor » Wed May 12, 2004 8:10 pm
Hi There,
7 Replies
5801 Views
Last post by Guest
Mon May 17, 2004 1:49 pm
Cleaning out my O2 sensors?
Replies: 7
by
Rockcrawler »
Sun Apr 18, 2004 10:43 pm
How can i clean them with out damnageing them? I put this post up to because i wanted to be the first one to post in here! :lol:
7 Replies
7505 Views
Last post by MHHodges
Sun May 16, 2004 9:26 pm
Bronco 2 spark problems
Replies: 6
by vj_M » Sat May 01, 2004 5:13 pm
ok, I replaced the TFI module, tryed a diferent coil and still i have no spark....
6 Replies
4353 Views
Last post by huffs
Fri May 14, 2004 9:57 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum