Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
BII rear DRv shaft
by
In the Zone »
Thu Oct 07, 2004 4:37 pm
Well i Did not have a lot of faith in it to begin with.....
0 Replies
2576 Views
Last post by In the Zone
Thu Oct 07, 2004 4:37 pm
What Transmission?
Replies: 3
by
PabroncoII »
Tue Oct 05, 2004 9:12 pm
I want to change from the factory transmission in my 1988 BII .Could anyone tell me what other transmissions will bolt up to it if any?
3 Replies
2005 Views
Last post by PabroncoII
Wed Oct 06, 2004 8:34 pm
tranny question
Replies: 1
by
jeepsubmarine »
Wed Oct 06, 2004 5:56 pm
my buddy has the same year broncoII as me (87). i have an a4ld he has a manual, question is will the manual bolt right up to mine? oh by the way we...
1 Replies
1629 Views
Last post by DBrown
Wed Oct 06, 2004 6:29 pm
4 Replies
2459 Views
Last post by plowboy
Wed Oct 06, 2004 1:20 pm
49 Replies
22666 Views
Last post by Nobody
Wed Oct 06, 2004 11:30 am
reversing leaf pack?
Replies: 13
by
FatMan »
Fri Sep 24, 2004 10:00 pm
i was gonna add this to the shackle flip thread but i figured id start a new one for this. :D
13 Replies
5914 Views
Last post by Rockcrawler
Thu Sep 30, 2004 9:42 pm
Early ranger Diff
Replies: 16
by
OCD4B2 »
Tue Sep 28, 2004 7:37 pm
Ok i was hitting the farm roads the other day to go back to this mazda, yeap it was a dead car. I took out the front seats and mounted them in the...
16 Replies
7103 Views
Last post by OCD4B2
Wed Sep 29, 2004 10:36 pm
full length add a leaf's
Replies: 15
by
DBrown »
Sun Sep 26, 2004 7:34 pm
I was looking at a full length add a leaf to give arount 2.5 of lift. has anyone tried these before? I am under the understanding that they would...
15 Replies
6231 Views
Last post by Nobody
Tue Sep 28, 2004 5:51 am
bushing questions?
Replies: 4
by
DBrown »
Mon Sep 27, 2004 8:22 am
what bushings do y'all run in the front with the D44 and duff coils?
4 Replies
2645 Views
Last post by My little pony
Mon Sep 27, 2004 7:05 pm
engine swap i
by
93ranger »
Sun Sep 26, 2004 3:21 pm
I have a 1993 ford ranger with a 4.0 l v6 and it is frozen so i might be buying the same engine but its out of a 1999 ranger both 4wd and i was just...
0 Replies
2590 Views
Last post by 93ranger
Sun Sep 26, 2004 3:21 pm
Front End Progress
Replies: 8
by
b2binbad »
Fri Jun 25, 2004 7:33 pm
Here are some pics of the narrowed/dovetail frontend progress.
8 Replies
3762 Views
Last post by b2binbad
Sat Sep 25, 2004 9:25 pm
idividual or kit components
Replies: 2
by
OCD4B2 »
Sat Sep 25, 2004 2:46 am
Ok, i was wondering if buying a suspension lift or purchasing seperate components one after the other was right. I have looked at skyjacker's...
2 Replies
1457 Views
Last post by DBrown
Sat Sep 25, 2004 7:29 pm
Header Question
Replies: 2
by
OCD4B2 »
Tue Sep 21, 2004 2:46 pm
Ok, beleive it or not, but one of my teachers knows a guy thats getting rid of a 351w. Custom headers r way way wayyyyyy to much. And i have heard...
2 Replies
1517 Views
Last post by FatMan
Sat Sep 25, 2004 6:17 pm
IT WON'T START !!!!
Replies: 21
by
Born Again B2 »
Fri Sep 17, 2004 9:03 pm
:frown: Well I have about 48 hours into trying to get my motor started. It turns over great, but won't fire. I posted on RRORC the same thing and got...
21 Replies
9955 Views
Last post by Born Again B2
Fri Sep 24, 2004 10:02 pm
boxing frame????
Replies: 15
by
FatMan »
Wed Sep 08, 2004 8:41 pm
just wondering what thickness flat stock would be good to to close off my frame (front end/rear end). im thinking 3/16 , or would 1/4 be better? im...
15 Replies
7300 Views
Last post by FatMan
Fri Sep 24, 2004 3:47 pm
almost there....
Replies: 7
by
wilber »
Wed Sep 22, 2004 6:07 pm
i did the night lights....
7 Replies
3894 Views
Last post by b2binbad
Thu Sep 23, 2004 3:17 pm
hp & torque on '87 302?
Replies: 3
by
searanch1 »
Wed Sep 22, 2004 3:25 pm
Anyone know the r.p.m.s at which the '87 f-150/bronco 302 puts out ? hp & ?torque? Been looking all over the net.
3 Replies
1831 Views
Last post by FatMan
Thu Sep 23, 2004 12:34 am
What's wrong?
Replies: 15
by
gullion_a86 »
Tue Sep 14, 2004 11:01 am
I have a 85' b2 w/ a 2.8L V6. Every time I start it up and let it warm up for about 2 minutes, when I go to put the gear in reverse it jumps. It...
15 Replies
7916 Views
Last post by plowboy
Wed Sep 22, 2004 11:35 am
3 link/4 link site....
Replies: 8
by
DBrown »
Thu Sep 16, 2004 7:43 pm
found this site, thought I would share.
8 Replies
3742 Views
Last post by plowboy
Wed Sep 22, 2004 7:27 am
No Fuel Pressure
Replies: 7
by
Trigger_2001 »
Sat Sep 11, 2004 6:58 pm
I have an 1988 Ford Bronco II with a fuel injected, 2.9 liter engine that has sat for six years. I had it running at one point, but now it refuses to...
7 Replies
3516 Views
Last post by DBrown
Tue Sep 21, 2004 5:29 pm
4 Replies
3012 Views
Last post by Phillippi
Tue Sep 21, 2004 3:04 pm
What went wrong
Replies: 7
by
gullion_a86 »
Sun Sep 19, 2004 9:52 am
My B2 ran out of gas last night and after I put gas in it, it wouldn't crank. There are sparks coming from the starter I think. I just hope that the...
7 Replies
3601 Views
Last post by b2binbad
Mon Sep 20, 2004 6:21 pm
what does my sticker tell me?
Replies: 6
by
PKAdetroitWLZ »
Sun Sep 19, 2004 2:09 pm
I went to look and see what trans I had and looked at the sticker in the door...
6 Replies
3420 Views
Last post by Nobody
Mon Sep 20, 2004 12:31 pm
NP435 Identification
Replies: 2
by
OCD4B2 »
Sun Sep 19, 2004 5:24 pm
Ok, now that i have picked out a tranny to go behind my 302, or possible 347, how can i identify the freakin thing? Do i check the door, can i check...
2 Replies
2042 Views
Last post by Nobody
Sun Sep 19, 2004 6:01 pm
np435
Replies: 27
by
wilber »
Sun Sep 12, 2004 4:16 pm
ok, wtf am i doing wrong? i finaly got the shifter in, and its fawked. i thought when i put the top plate on that the forks were where they neeeded...
27 Replies
12107 Views
Last post by wilber
Sun Sep 19, 2004 6:21 am
2.9L parts
Replies: 3
by
OCD4B2 »
Thu Sep 16, 2004 10:32 pm
Ok....I need to get everything done for what i can use from my original motor to the 302 im putting in. I have a 1990 Bronco II, 2.9L v6, and im...
3 Replies
1971 Views
Last post by DBrown
Sun Sep 19, 2004 5:13 am
T-5
Replies: 24
by
OCD4B2 »
Mon Sep 13, 2004 7:34 pm
Was there any ford v8 trucks(any year) that came with a t-5? If so, then did any of em come with a borg warner 1350 t-case? I need to find an adapter...
24 Replies
10354 Views
Last post by OCD4B2
Sun Sep 19, 2004 1:02 am
NP435 bracket?
Replies: 15
by
DBrown »
Fri Aug 27, 2004 10:11 am
Nobody, do you have any pics or demetions of the bracket you made to get the Land Cruiser stuff to work?
15 Replies
7564 Views
Last post by Nobody
Sat Sep 18, 2004 10:44 am
BW1350 V8 mildly built???
Replies: 4
by
NightKrawler »
Thu Sep 16, 2004 6:13 am
I'm gonna put a mildly built 302 into my 84 Bronco II and my only real concern is will the T-Case handle the power or will the chain explode?
4 Replies
2628 Views
Last post by NightKrawler
Thu Sep 16, 2004 10:30 pm
Sway Bars?
Replies: 2
by
gullion_a86 »
Thu Sep 16, 2004 11:15 am
I have been wondering if I take the sway bars off my truck would it drive better offroad? I heard that before and I was thinking about trying it.
2 Replies
1709 Views
Last post by b2binbad
Thu Sep 16, 2004 5:37 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum