Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Email I got today...
Replies: 9
by
Phillippi »
Thu Oct 27, 2005 3:11 pm
Here is an email that I got today. I thought I would post it in hopes that the writer of the email will check out this site for some answers.
9 Replies
3896 Views
Last post by TC
Mon Oct 31, 2005 11:22 am
free lift....
Replies: 9
by
DBrown »
Sun Oct 09, 2005 3:30 pm
well I was doing some measuring the yesterday and started to dig threw the growing pile of parts and I came up with something cool.
9 Replies
3792 Views
Last post by DBrown
Sun Oct 30, 2005 8:38 pm
Problem With Brake Fade
Replies: 3
by
NinjaLogic »
Fri Oct 28, 2005 8:57 am
Hi i got a problem with my stock brake system, for some reason even after bleeding the system 5 times! the brakes are still fading bad, we changed...
3 Replies
1313 Views
Last post by NinjaLogic
Fri Oct 28, 2005 11:56 pm
Hydroboost
Replies: 9
by
Nobody »
Sun Oct 23, 2005 7:48 pm
My Bronco II brakes have always sucked. They stop fine, but the peddle was always soft. Since the stock master cylinder is only 15/16 bore, I was...
9 Replies
4163 Views
Last post by EBSTEVE
Tue Oct 25, 2005 7:58 am
Wristed Arm Inspection
Replies: 7
by
Nobody »
Sun Oct 23, 2005 8:03 pm
Since I had to replace the radius arm bushings on my Bronco II, I decided to pull the wristed arm so I could inspect it. It's been nearly 4 years...
7 Replies
2771 Views
Last post by DBrown
Tue Oct 25, 2005 4:59 am
O.B.A. ?'s
Replies: 23
by
FatMan »
Thu Oct 20, 2005 2:56 am
okay i was wanting to do this to my rig here pretty soon. im just going to set it up without tank for now and will add the tank later. out of all the...
23 Replies
10202 Views
Last post by FatMan
Sun Oct 23, 2005 8:32 pm
2 Replies
2026 Views
Last post by ranger5.0
Thu Oct 20, 2005 8:19 pm
eb d30/d44 ?'s
Replies: 3
by
FatMan »
Wed Oct 19, 2005 2:38 pm
hey i just wanted to know really quick if the eb d30 has anything in common with the eb d44. i may have a line on a free d30 and i wanted to know it...
3 Replies
1419 Views
Last post by Nobody
Wed Oct 19, 2005 8:52 pm
disk brake question...
Replies: 15
by
DBrown »
Sun Oct 09, 2005 3:02 pm
I guess this one is for Nobody mainly.....
15 Replies
4717 Views
Last post by Nobody
Mon Oct 17, 2005 7:48 pm
84 B-II Console wiring ?
Replies: 6
by
medic1657 »
Thu Oct 13, 2005 9:42 pm
First time poster here...Recently purchased an 84 B-II to tinker with. Plan on putting back to original condition as time and money allows. The...
6 Replies
2089 Views
Last post by medic1657
Sun Oct 16, 2005 9:20 pm
Justa wanna put in a 4.0 with 5 speed
Replies: 6
by
straightbII »
Mon Oct 10, 2005 10:06 am
What is the simplest 4.0 5 speed combination that I can get to bolt into my 85 BII that is currently a 2.8L with OD automatic? BII is in excellent...
6 Replies
2311 Views
Last post by ranger5.0
Fri Oct 14, 2005 7:46 pm
my 85 bronco II
Replies: 3
by
abenson »
Sat Oct 01, 2005 1:50 pm
My freind just gave me his bronco II it is an 1985 eddie baure eddition it has a 2.8,2.9 im not sure, and a 5 speed, 4x4. And i wanted to make it a...
3 Replies
2118 Views
Last post by ranger5.0
Sun Oct 09, 2005 7:17 pm
Bellhousing Bolts
by
malcolm »
Sun Oct 09, 2005 2:06 pm
After lending my 85 Bronco II to my brother, it returned with some very nasty noises from the transmission.
0 Replies
1229 Views
Last post by malcolm
Sun Oct 09, 2005 2:06 pm
Question about lifts
Replies: 3
by
binder »
Mon Oct 03, 2005 9:02 pm
I am currently installing a 4" Rough Country lift on an 85 BII. I need to purchase longer front brake lines and longer front sway bar end links. Any...
3 Replies
1538 Views
Last post by binder
Wed Oct 05, 2005 7:53 am
frame
Replies: 4
by
partsman66 »
Fri Sep 23, 2005 8:32 am
Anyone here ever just stripped the body off a BII and just used the frame and a cage for offroading.I have a BII that has been flipped on body is no...
4 Replies
2162 Views
Last post by partsman66
Mon Oct 03, 2005 10:05 am
F-250 Pilot Bearing
Replies: 2
by
Dreded »
Sat Oct 01, 2005 10:47 am
Ok iv phoned 3 parts stores now and none of them had a Pilot bearing listed for my F250 Tranny. mated to a 302 does anyone know if it needs one might...
2 Replies
1293 Views
Last post by Dreded
Sun Oct 02, 2005 11:32 am
acc. belts?
Replies: 3
by
DBrown »
Mon Sep 05, 2005 4:19 pm
ok, I have a problem....
3 Replies
1527 Views
Last post by DBrown
Sat Oct 01, 2005 2:50 pm
Crawl Ratios
Replies: 2
by
Happy_Jack »
Thu Sep 29, 2005 9:43 am
What crawl ratios would everyone "like" to have. I'm running a C-5 auto. Can I get too low? If I use stock info on my BII I get a crawl ratio of...
2 Replies
1628 Views
Last post by DBrown
Sat Oct 01, 2005 2:47 pm
BII runs bad after 1st minute
Replies: 2
by
lferrin »
Wed Aug 31, 2005 2:45 pm
My 88 BII runs rough about one min. after it starts, whether cold or hot. If I turn it off and restart it is fine. If I rev up to 3500 rpm is goes...
2 Replies
1663 Views
Last post by abenson
Sat Oct 01, 2005 1:54 pm
Skyjacker Question
Replies: 7
by
Happy_Jack »
Fri Sep 09, 2005 12:44 am
I have an 88 BII that was 2wd and I'm converting it to 4wd. I pulled the A4LD and put a C-5 in. I have the Skyjacker 6" lift with extended radius...
7 Replies
3130 Views
Last post by Happy_Jack
Sat Oct 01, 2005 2:17 am
2 inch body + 2 inch suspension
Replies: 1
by
1988b2 »
Wed Sep 07, 2005 6:13 pm
1988 bronco II 5 speed 2 wheel drive. Will a 2 inch body lift need any extended steering parts or brake lines or gas tank filler neck extension or...
1 Replies
1653 Views
Last post by Dreded
Fri Sep 30, 2005 12:16 am
stalling
Replies: 2
by
1988b2 »
Sun Sep 11, 2005 3:04 pm
my 2.9 stalls on inclines and runs great on flat surfaces. Why? its not out of gas.
2 Replies
1602 Views
Last post by Dreded
Fri Sep 30, 2005 12:03 am
James Duff Stage 1
Replies: 17
by
Reinforcements »
Wed Aug 31, 2005 4:27 pm
How much does a stage 1, 3in. lift alter the haandling of my b2? Would it make it more or less prone to roll-over??
17 Replies
10808 Views
Last post by Dreded
Fri Sep 30, 2005 12:01 am
leveling spacer
Replies: 5
by
1988b2 »
Sun Sep 25, 2005 6:14 pm
i got a 88 ranger 4x4. I took the nut off the coil and the coil is free. How do i get the coil out so i can get my spacers in? I dont have a coil...
5 Replies
2787 Views
Last post by ranger5.0
Tue Sep 27, 2005 8:30 pm
coolant and cap
Replies: 2
by
1988b2 »
Fri Sep 23, 2005 11:57 am
my radiator cap wont come off my 88 ranger 2.9 i untwisted it all the way and i still wont come off how? Also how much coolant do i put in like 2...
2 Replies
2136 Views
Last post by B2JAY
Mon Sep 26, 2005 9:55 am
Explorer Susp. under a B2
Replies: 6
by
Reinforcements »
Thu Aug 18, 2005 11:38 am
I just recently purchased my first vehicle which just happens to be a 1986 Bronco II. The guy I bought it from siad something about using the leafs...
6 Replies
3997 Views
Last post by DZK007
Sun Sep 25, 2005 8:14 pm
fuel rail??
Replies: 5
by
1988b2 »
Wed Aug 31, 2005 6:15 pm
a guy told me that the fuel rails go bad on the 2.9 engines. is this true and what is a fuel rail?
5 Replies
2810 Views
Last post by ranger5.0
Sun Sep 25, 2005 9:55 am
lift for 33's
Replies: 6
by
rlocke2 »
Sun Sep 18, 2005 6:44 pm
what size lift do i need to run 33x12.50 bfg mud terrains without clearance issues on my 87 b2? right now i have 15 x 8 classic 2's and 235x75x15...
6 Replies
2985 Views
Last post by ranger5.0
Wed Sep 21, 2005 8:32 pm
i want to go full size
Replies: 3
by
daniel haire »
Fri Sep 16, 2005 10:19 pm
i want to put full size axles under the b2 i have a 9in for the rear but i dont no what i should use for the front and would i beable to have the...
3 Replies
1700 Views
Last post by Rockcrawler
Sun Sep 18, 2005 1:45 pm
mirrors
Replies: 10
by
1988b2 »
Tue Aug 23, 2005 6:49 pm
where can i get a nice strong set of side view mirrors for a 1988 ranger?
10 Replies
4217 Views
Last post by 1988b2
Sat Sep 17, 2005 6:29 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum